|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Application: recycled / reclaimed water Pipe series: aquatherm lilac pipe SDR7.4/SDR11 The lower the SDR the higher the pressure rating Material: fusiolen PP-R Colour: Lilac Form supplied: L= 4 m straight lengths (20 - 125mm), L= 5.8 m straight lengths (160 - 250mm) Download general information aquatherm lilac pipe SDR7.4/SDR11 Please only use aquatherm proprietary pipe clamps!
Reclaimed and recycled water sources, and rainwater catchment systems are being specified and installed much more frequently as building and plumbing codes are updated to allow this as means for improving water conservation. The codes will require that the system be kept entirely separate from the potable water supply, and that the piping be color-coded and labeled to identify it as non-potable. The water from these sources can be used for:
Welding procedures videos:
20-63mm: Socket Fusion 50-125mm: Socket Fusion 160mm and up: Butt welding 20-250mm: Electrofusion Please also refer to chapter "Training / Processing Welding Videos"
Available dimensions
UV Resistance Pipes and fittings made from fusiolen PP-R are normally not installed where subject to UV-radiation. All aquatherm PP-R pipes and fittings have UV stabilizer to bridge transport and installation times. Maximum storage time in the open air is 3 months under Australian UV-conditions. For the application in open air aquatherm offers composite pipes with an UV-protective layer made from black polyethylene, which excludes damages caused by sunlight. Aquatherm PP-R fittings have to be protected against sunlight by using a black UV-resistant adhesive tape. Painting the aquatherm PP-R pipes and fittings with an UV resistant epoxy based primer or lagging the aquatherm PP-R pipes and fittings with an UV resistant insulation is sufficient as well to protect the PP-R pipe system from UV damage. Available types of pipe:
Peeling of the UV layer When welding UV pipe peel off the UV layer off the aquatherm pipe before fusion. Push the end of the UV pipe into the guide of the peeling tool. Peel off the UV layer up to the top of the peeling tool. It is not necessary to mark the welding depth as the back stop of the peeling tool indicates the correct welding depth. Before starting the fusion, check if the UV layer has been completely removed.
Peeling of the UV layer Click here for more information on the pipe peelers for the UV pipe
Peeling of the UV layer (option 2):
NEW: Aquatherm offers new solution for painting the aquatherm PP-R pipe systems Click on below picture to download Technews No.14 2015
For more information, click here to download the aquatherm lilac pipe brochure |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||